Maintenance of your BoxPlunge
Read everything here.
Clean the pre-filter:
Frequency: once a week
Takes less than 3 mins!
1) Open lid of BoxPlunge 2) Let the water calm-down 3) Carefully lift the pre-filter (Be very careful to not let debris float & fall) 4) Wash the pre-filter, you may use a brush 5) Gently install pre filter by slipping it back into pump inlet (do it lightly and gently)
Change filter cartridge:
Frequency: once a month
Takes less than 5 mins!
1) Open lid of BoxPlunge 2) Undo PVC gray union 3) Take complete filter canister away from the tub 4) Untwist the blue cap on filter 5) Empty filter and swap to a new filter cartidge. Once new cartdige in-place fill canister with clean water 6) Reassemble the filter blue top 7) Place underwater and twist PVC union back
Model: 2.5" x 10"
How to avoid mold growth on the lid's rubber seal? (Especially if outdoors)
After use, dry the top frame of the cold plunge with a microfiber cloth
Prevention: Keep a microfiber washcloth near freezer & always wipe up stray splashes and drops after you get out. Maintenance: Once or twice a month you can wipe it with a 1:1 white vinegar/water solution. Removing current mold: you can use hydrogen peroxide or straight white vinegar, or "cleaning vinegar," which has a stronger acidity. Put the H2O2 in a spray bottle and saturate the areas with the mold. Let it sit on the surface for at least 10 minutes. Use the scruffy side of a sponge. Follow up with a damp cloth. This will deactivate the spores but it may not remove the stains. To remove the stain you'll need a mold stain remover.
Changing the water:
Takes less than 10 mins!
1) Connect the included bilge pump to a hose 2) Place the bilge pump at the bottom of your cold plunge 3) Carefully, connect the bilge pump to the nearest power outlet 4) Point the hose somewhere where water may flow 5) Once empty use a towel and some vinager to clean and dry the rest of the cold plunge 6) Re-fill it with water until the "MAX" level mark
Frequency: Every 3 - 6 months
Going away? Store your BoxPlunge!
Drain & dry unit if you are going out of town
1) Empty the unit 2) Fully dry the unit 3) Place 2 large "silica pouches" to absorb humidity and avoid bad smells
Dry it well and
use these x2: Silica Pouches
Add Hydrogen peroxide (H2O2) To your water (optional)
To calculate hydrogen peroxide amount use the following calculator:
Learn about ozone (A must!)
To increase ozone cleaning simply press on more tabs on your timer
Increase ozone cleaning!
Example of an ozone routine:
Tabs pressed at:
-
12:00 am - 12:30 am